Results 1 to 10 of 16

Thread: running M19's and 604's at the same time?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Hostboard Member juniper's Avatar
    Join Date
    September 8th, 2011
    Posts
    368
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    running M19's and 604's at the same time?

    Was wondering if running both pairs of these speakers at the same time would be worth a try? My 604's sit on top of my 19's.... would there be anything gained by doing this, or would the sound quality degrade?

  2. #2
    Senior Hostboard Member bowtie427ss's Avatar
    Join Date
    July 24th, 2006
    Location
    Rural NY
    Posts
    3,901
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    26 Post(s)

    Re: running M19's and 604's at the same time?

    I think the only correct blanket answer is "it depends".

    There are lots of variables to be considered. But in basis, you have 4 reproducing elements that each have specific "ideal" bandwidth coverage areas. If you had enough available amplifier channels and 4 way active filtering, you could operate each element in it's ideal range.

    For example the 416 in the 19 enclosure would cover the lowest octave or two, then the LF section of the 604 would take over for the midbass/low midrange, then pass the signal off to the 802/811 to cover the high midrange up into the low HF finally crossing to the HF section of the 604 which is really optimized for an XO much higher than the stock 604's cross them.

    Just paralleling them together with stock passive networks on a single amplifier channel by nature is going to cause some comb filtering and probably some cancellation of lower frequencies as well as probably some crazy room modes. But, this is all variable by virtue of placement, and your room.

    I think some basic predictions can be made, but it really will be very dependent on your room and positioning as to whether the overall effect is "good or bad".

    Just my .02 of course.......................
    Not all vegetables make good leaders.

  3. #3
    Senior Hostboard Member
    running M19's and 604's at the same time?


    Alien_Shore's Avatar
    Join Date
    April 25th, 2012
    Location
    Virginia
    Posts
    750
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    5 Post(s)

    Re: running M19's and 604's at the same time?

    great reply from Bowtie.
    My simple answer would be, not unless you are a cross-over guru, or don't care about messy sound.
    - Mike

  4. #4
    Senior Hostboard Member cradeldorf's Avatar
    Join Date
    October 16th, 2010
    Location
    Muskegon Mi.
    Posts
    1,334
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    4 Post(s)

    Re: running M19's and 604's at the same time?

    My suggestion, try it. If you don't like it don't do it.

  5. #5
    Senior Hostboard Member juniper's Avatar
    Join Date
    September 8th, 2011
    Posts
    368
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: running M19's and 604's at the same time?

    Thanks gentlemen!!! sounds like a complicated situation with conflicting perameters.... amazing how different these speakers sound.... with the right recording, they are amazing, more amazing they are both called "studio monitors" and sound so different....

  6. #6
    Senior Hostboard Member
    running M19's and 604's at the same time?


    Alien_Shore's Avatar
    Join Date
    April 25th, 2012
    Location
    Virginia
    Posts
    750
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    5 Post(s)

    Re: running M19's and 604's at the same time?

    Can't wait to get mine into a cabinet and listen to it! It's pretty amazing just laying here on the floor hahah

    Juniper, what cabinets are your 604's in?
    - Mike

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This forum has been viewed: 28131802 times.